evoSWITCH
BE FREE
Make the most of your travels with a system that provides
all the features of advanced home automation in your vehicles.
Monitoring | Diagnostic | Display
This system provides all the features of advanced home automation in your vehicle. It allows you to control the electrical and electronic systems on board such as lighting, air conditioning, entertainment systems from the tablet connected to the network.
Monitoring
- Battery capacity, autonomy, charge and discharge
- Heating management
- Information about water levels, temperature, vehicle levels, gas
- Creation of Modes: Day, Night, Travel, …
Display
- Integrated tablet of various sizes
- Customizable user interface according to your needs
Diagnostic
- Real-time display of defects
- Validation of the global installation at the end of the production line by simple visualization (productivity gain)
The AMOY system from TBB Power is the next generation electrical system for motorhome. It is a highly integrated system with a single box plus few surrounding components like monitor, sensors etc. Compatible with multiple communications including CI-bus, Bluetooth and CAN, motorhome owner can approach equipment through system monitor and mobile APP for maximum convenience and ease of use.
The MEZZO system is designed for motorhome or camper van, with many new technologies applied, including digital switching, wireless switch, Bluetooth, lithium battery, etc. With an integrated master power module, it will significantly reduce valuable space, time and cost of motorhome builder.
evoSWITCH AMOY
The AMOY system from TBB Power is the next generation electrical system for motorhome. It is a highly integrated system with a single box plus few surrounding components like monitor, sensors etc. Compatible with multiple communications including CI-bus, Bluetooth and CAN, motorhome owner can approach equipment through system monitor and mobile APP for maximum convenience and ease of use.
SYSTEM DIAGRAM
SYSTEM HIGHLIGHTS
- A fully integrated master power module with built in battery charger, booster charger, MPPT charge controller, system control unit, battery management and digital switching
- Dedicated outputs for typical load with smart control which suitable for motorhome
- Standard 30A version meets most application
- 7” or 10” LCD for system motoring and controlling
- Bluetooth connectivity to support mobile APP is standard; 4G connectivity for remote control is optional
- System control unit to manage and coordinate the whole system
- CI-BUS compatible to communicate with CIBUS equipment like Truma/Adle Heating, Dometic air-conditioner etc.
- TBB’s smart sensor like GAS sensr, Door sensor, TPMS etc can be added
- Lithium battery supports 200A discharge current; and communication compatible allows it be charged or discharged properly by other devices in system
Modules in the AMOY system
Master power module EMP30F-A4
Technical features
- Full integrated with below functions into a single box:
- AC charger 30A
- MPPT solar charger controller 30A
- Booster charger 30A
- Built in system control unit to coordinate all devices in system
- Built in Bluetooth connectivity to be compatible with smart sensor
- Water tanks measurement
- Plenty of outputs for smart DC loads management:
- 2 relay controlled plus by-pass output
- 2 chip set controlled dimmable outputs
- 1 motorized driven controlled output
- 2 dual sources output which powered by auxiliary and starter batteries both
- 2 relay controlled outputs
- 3 D+ simulated outputs
- 5 constant alive outputs/li>
- 1 permanent alive output
- 6 dry contact outputs
- 3 dry contact inputs
- RS485, CAN, RF, Bluetooth connectivity compatible
- Automotive class connector for plug and play
System Monitor A10/A7
Technical features
Our system monitors offer the approach for user to access critical information at a glance and to control the load at the touch of a finger. In the meantime, communication bus compatible products such as heater, air conditioner and a host of sensors can be added as well for maximum convenience and ease of use.
- System monitor with active data and history record
- 10” TFT with resolution 1280 x 800px
- 7” TFT with resolution 1024 x 600px
- Android based
- 1GB DDR3 and 8GB EMMC
- Built-in Bluetooth to support mobile APP
- Spring fixture for easy installation
- Multiple communication ports USB, RS485, CAN
- TF card included
Wireless Switch Panel PICO 2
Technical features
- Surface mounting
- RF wireless technology, cost saving on cable harness
- The button with load’s icon
- Available in Black and White
- Dimension 72 x 72 x 11.5 mm
Wireless Switch Panel PICO 3
Technical features
- Surface mounting
- RF wireless technology, cost saving on cable harness
- Touch button with load’s name printed
- Glass panel with fluorescent indicating light
- Dimension 70 x 69 x 19 mm
4G Module Data Logging Stick
Technical features
4G can be added for remote monitoring and telemetric
- 4G connectivity
- An external communication device to connect Amoy system with cloud; it offers a convenient way to monitor and control system remotely
- Local SIM is available
AC Electrical Box FB15
Technical features
- With 2pcs RCCB 30mA, 16A
- With 1pc CB 16A for AC equipment not powered by inverter
- Input/output designed as WAGO terminal for quick installation
Lithium Battery M12-100/P
Technical features
- Rated capacity 12.8V 105AH
- Long cycle life, over 3000 cycles at 100% DoD @25°C
- Supports max discharge current 200A
- Supports parallel connection up to 8pcs
- Built-in BMS with automatic balancing and complete protection
- Built-in high precision (±0.1A) shunt for SOC calculation
- Built-in heater element to support battery be charged at temperature -20°C
- Special designed BMS to reduce idle power by 90% (<0.1mA) upon battery turns off
- Predebugged BMS software compatible with TBB power system to assure designed lifespan of lithium battery
- Supports CAN and RS485 communication
- Supports remote battery switch
Size: 310 * 165 * 187mm
Weight: 11kgs
Remote Battery Switch
Technical features
- A latching switch to turn M lithium battery ON/OFF remotely, once the battery is switched off, the idle power consumption is down to 100uA which is only 8% of many competitors.
- Connected with battery by communication cable
- Could be installed at any location with easy access
High Frequency Inverter e-Ray Series IH1500L-BYP
Technical features
- Pure sine wave output
- Rated power 1500W and full power output even at 35°C
- High efficiency up to 90%
- With USB charger, 5V2A
- With dry contact input and output
- Power saving mode is available and the threshold value to enter into power saving mode is settable
- With by-pass output and built-in ground relay; AC in and one of AC out are WAGO terminal
- Model of rated power 2000W is optional
RSE-A
Technical features
-
- Capacitive water tank sensor
- Capacitive design
- Top installation
- Precise measurement with 5% as one step
- Non-contact design, insensitive to dirt and solids in the water
- Capacitive water tank sensor
RSA-RSF
Technical features
-
-
- Resistive water tank sensor
- Resistive design
- Side installation
- Measurement with 25% as one step
- Resistive water tank sensor
-
Lighting control module P6
(When more dimmable lighting control is required)
Technical features
-
-
- With 6 chip set controlled outputs for smart lighting management
- Dimmable lighting with minimum 1% step brightness adjustment
- Color temperature is tunable
- Protected by software and no fuse is needed
- Rated current 42A
- 9A x 3
- 5A x 3
- Built-in RF compatible for wireless switch panel
- Quick connector for plug and play
- With 6 chip set controlled outputs for smart lighting management
-
AC Electrical box EB02
Technical features
- With 1pcs RCCB 30mA, 16A
- Input/output designed as WAGO terminal for quick installation
evoSWITCH MEZZO
TBB’s MEZZO is designed for motorhome or camper van, with many new technologies applied, including digital switching, wireless switch, Bluetooth, lithium battery, etc. With an integrated master power module, it will significantly reduce valuable space, time and cost of motorhome builder.
SYSTEM DIAGRAM
SYSTEM HIGHLIGHTS
- A fully integrated Master Power module with built in battery charger, DC-DC charger, MPPT controller, battery management, digital switching and water tank measurement
- Master Power module 18A or 30A model is optional
- Wireless switch panel for convenient cable harness
- Optional as a stylish 7’’ or 4.3” LCD system monitor, both of them come with Bluetooth connectivity to support mobile APP
- Smart sensors like GAS, leveling and TPMS are available
- CIBUS equipment Truma heater is compatible
- Lithium battery supports 150A discharge current; and communication compatible allows it be charged or discharged properly by other devices in system
- Plug and play for quick installation
Modules in the MEZZO System
Master Power Module EMP18E-M6 / EMP30F-M6
Technical features
- Full integrated with below functions into a single box:
- AC charger 18A or 30A
- MPPT Charger 15A or 30A
- Booster Charger 15A or 30A
- Smart Sensor Compatible: GAS, Leveling, TPMS etc.
- Water tanks measurement
- Plenty of outputs for smart DC loads management:
- 5 relay controlled outputs
- 1 motorized driven controlled output
- 1 D+ simulated outputs
- 5 constant alive outputs
- RS485, CAN, RF compatible
- Automotive class connector for plug-n-play
Wireless Switch Panel PICO II
Technical features
-
-
- Surface mounting
-
- RF wireless technology, great saving on cable harness
-
- The button with load’s icon
-
- Available in Black and White
-
- Dimension 72 x 72 x 11.5mm
-
System monitor L4
Technical features
Stylish monitor which offers the approach for user to access critical information at a glance and to control the load at the touch of a finger
-
-
- LINUX operation system based
-
- 4.3’’ size
-
- Display battery information, power information, water tank level, DC load control etc.
-
- Built in Bluetooth to support mobile APP
-
System monitor L7
Technical features
Stylish monitor which offers the approach for user to access critical information at a glance and to control the load at the touch of a finger
-
-
- LINUX operation system based
-
- 7“ LCD with resolution 1024 x 600px
-
- Built in Bluetooth to support mobile APP
-
- Display battery data, inverter data, water tank level etc.
-
Battery shunt BM500
Technical features
-
-
- Measured current is up to 500A
-
- Compatible with AGM, GEL or LFP battery
-
- Contact ratings 2A@30Vdc or 0.5A@125Vac
-
- Measurement accuracy
-
Current : : +/- 0.4 %
Voltage : +/-0.3 %
High performance lithium battery M12-100/P
Technical features
-
-
- Long cycle life, over 3000 cycles at 100% DoD @25°C
-
- Supports max discharge current 150A
-
- Supports parallel connection up to 8pcs
-
- Built-in BMS with automatic balancing and complete protection
-
- Built-in high precision (±0.1A) shunt for SOC calculation
-
- Built-in heater element to support battery be charged at temperature -30°C
-
- Special designed BMS to reduce idle power by 90% (<0.1mA) upon battery turns off
-
- Predebugged BMS software compatible with TBB power system to assure designed lifespan of lithium battery
-
- Supports CAN and RS485 communication
-
- Supports remote battery switch
-
Size: 310 * 165 * 187mm
Weight: 11kgs
Remote battery switch
Technical features
-
-
- A latching switch to turn M12-100 ON/OFF remotely
- Connected with battery by communication cable
-
- Could be installed at any location with easy access
- A latching switch to turn M12-100 ON/OFF remotely
-
High frequency inverter IH1500L-BYP / IH2000L-BYP
Technical features
-
-
- Pure sine wave output
-
- With by-pass output and built-in ground relay
-
- Rated power 1500W / 2000W and full power output even at 35°C
-
- AC in and one of AC out are WAGO terminal for quick connection
-
- High efficiency up to 90%
-
- With USB charger, 5V2A
-
- With dry contact input
-
AC electrical box FB15
Technical features
-
-
- With 2pcs RCCB 30mA, 16A: one for shore power input and one for inverter output
-
- With 1pc CB 16A for AC equipment on-grid only
-
- Input/output designed as WAGO terminal for quick installation
-
Water tank sensor RSA
Technical features
-
-
- Measurement level 0%, 25%, 50%, 75% and 100%
-
- Top installation
-
- Probe length can be tailor-made to fit tank depth
-
evoLED
LED diffusion technology
Flexible LED
Contemporary design
Unmatched light diffusion
Reduced electrical power
evoENERGY
Auxiliary Batteries & Solar Panels
Acid: Conventional, AGM, Gel
Professional
Lithium, Lithium BMS
Monocrystalline panel
Flexible and semi-flexible panel
…
